Con-Evator

Con-Evator

Transport warning

1. Missing material.
2. An unsuccessful transport is if the bottom flap is not down more than 2 sec. (emptying the SVR for material).
3. Air leaking from pipes.
4. Suction pipe not adjusted correctly
5. The slide valve is not opening.
6. Air leaking from SVR Bottomflap seal.

1. Check if the material source contains material.
2. Check if the bottom flap is functioning (both physically and the signal is connected correctly).
   Check the conveying time is set correctly, for full SVR. Adjust time if SVR is not full at each transport.
3. Check if pipes are leaking.
4. Adjust suction pipe with the correct airflow
5. Check if the slide valve is opening and material is flowing through.
6. Change the bottom flap seal.

Con-Evator

Motor Alarm

1. The motor is malfunctioning.
2. Motor protection is triggered.
3. Motor protection signal is missing.
4. Motor is too hot.

1. Check if the motor is malfunctioning.
2. Reset Motor protection (see electrical drawings), maybe adjust Amps triggering the protection.
3. The filter is blocked or the pipe is clogged.
4. Check if the motor protection signal is connected correct (see electrical drawings).
5. Let the motor cool down and check if the material is too hot or the blower can't get fresh air.